Metanet Forums

This is what you got to do:

1: Go to Microsoft word.
2: Make a WordArt.
3: Click on your newly created WordArt; there should be two toolbars.
4: Click on the 3d block on one of the toolbars.
5: Click 3d settings.
6: Mess around with the settings; tilt it, changes the lighting, texture, pts., etc; do not undo.
7: Do step 6 for about 10 minutes.
8: Now, hold down Ctrl+z!
9: To reset, hold down Ctrl+y.

Any confusion, tell me.

Yeah...

Well I can't seem to find the so called 3D block, it doesn't show up, which toolbar is it on?
This is Microsoft Office Word 2003 by the way.

WordArt is old...

This is probably the most pointless topic I have seen in some time (and this is the most pointless post I have made in some time...)